|
By IWL BCNU - 11 Years Ago
|
|
What is the proper gasket stack when installing the oil pickup thru the pan? I have a concaved paper type washer, a copper washer, and a copper swedge ring that all fit the nut and came in the kit.
|
|
By Talkwrench - 11 Years Ago
|
|
From memory the flat copper washer on the inside the tapered copper one should be the outside.. [think Ive done it once with just the outside one and it was fine] You can add a small amount of high temp RTV on the outside as your doing it up, I don't think they really leak from there, what you will have to watch for is when you offer the pipe up to the oil pump, small amount of grease on the pipe as it goes through the large rubber seal, That has a collar type of washer arrangement and the jamb nut goes against that, don't do that jamb nut up too tight.. if you get a leak that's where you will get one. If Ive missed something Im sure others will chime in. good luck.
|
|