|
By LON - 16 Years Ago
|
|
Yes ,I know it's not powered by a Y .Maybe he might take out that motor and replace it with a stroked "Doc " Eaton special . Either way, this is one trick 55 .I would not mind it parked in my garage . http://www.streetrodderweb.com/features/0906sr_1955_ford_customline/index.html Lon
|
|
By Moz - 16 Years Ago
|
|
wow thats one nice car
|
|
By mctim64 - 16 Years Ago
|
I like the little emblem he made except a 429 isn't even a Y type block. 
|
|
By charliemccraney - 16 Years Ago
|
|
Is the emblem painted on there? I like it.
|
|
By BFOOTER03 - 16 Years Ago
|
|
It appears to be painted on based off the picture in the magazine. With out a doubt it has a sweet stance and is one sharp looking ride. There is also a mention of Red's Headers and the fact that they now make Ram Horns for they Y in the same issue.
|
|
By MoonShadow - 16 Years Ago
|
I guess its one of those "wide block" engines that keeps popping up on EPAY! Chuck in NH 
|
|
By aussiebill - 16 Years Ago
|
|
Lon, cussobill here, can anyone give me contact details for Kariol Miller, Email would be good. How do you start new post, i unfortunatley have to chime in to say something, thanks mate! aussiebill. P.S guys make sure you Allways wear eye protection when grinding! after haveing piece of metal dug out of my eye recently!.
|
|
By Hoosier Hurricane - 16 Years Ago
|
|
Bill: Karol doesn't have internet. Bruce at Y Block magazine will not give out addresses, but will forward a letter if you send it to Bruce to be addressed. A few weeks ago when his name popped up here, it reminded me that I should send him a letter, and I did. I haven't heard a reply, he usually does. I am a little concerned. But he takes long vacations, like to S America, maybe he's on vacation.
|
|
By Pete's Panel - 16 Years Ago
|
|
Hi Bill, the Topic tab next to Reply is for new posts, it's also on the top of each section page.
|
|
By aussiebill - 16 Years Ago
|
|
John, thanks for that note re Kariol , i believe he may be making Australia one of his vacations, either coming or been and gone and was eager to see if it was possible to meet up with the gentleman. i will try with bruce from the magazine. Petes panel, thanks for topic note, simple once you know. best regards . aussiebill.
|
|
By Johnson Rod - 16 Years Ago
|
|
Allways wear eye protection when grinding! after haveing piece of metal dug out of my eye recently!.
Good point, wear goggles or better yet goggles and faceshield when grinding or wire brushing. A long time back, for what ever reason I looked up at the dropped ceiling above my grinder and noticed it was growing hair. Upon closer inspection if found wire wheel wires stuck in the ceiling!!! Convinced me to wear eye protection...
|