|
By mctim64 - 14 Years Ago
|
A buddy of mine sent me this link, thought I'd like it, He was right.  Too much for me though.  http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&&item=190486468707&ssPageName=ADME:B:EF:MOTORS:1120
|
|
By oldcarmark - 14 Years Ago
|
|
Thats a real nice set of wheels!Nice to see they kept the Y-Block.
|
|
By Oldmics - 14 Years Ago
|
|
Intake,air filters and carbs are not correct for a real M 260 setup BUT is is a really nice car. I would like to have it and straighten it out to make it a real M 260 (O.K. a stroker M 260) Oldmics
|
|
By MarkMontereyBay - 14 Years Ago
|
|
That guy is local to me. Autohaus in Los Gatos, Ca. In fact the car is photographed in front of Campbell High School where I went many, many decades ago. He has been trying to get off this for a long time (couple years). I would also suggest going to their website and look at some other stuff, especially the 57 Ford Custom 300 roller. If I remember correctly, it was an original 12k local 6 cylinder car. The place has a hard-nosed, wheeler-dealer reputation but I think the economy is getting to them. Might be some deals there.
|
|
By yalincoln - 14 Years Ago
|
|
an interesting obsevation, the engine is a 292 and it was dyno'ed in ohio.
|
|
By charliemccraney - 14 Years Ago
|
|
...with a 750 Holley. Interesting torque curve.
|
|
By Oldmics - 14 Years Ago
|
Isnt that great-typical used car saleman  Touting a dual quad , 347 stroker and showing specs for a single carb 292 Perfect Oldmics
|
|
By Hollow Head - 14 Years Ago
|
Who cares about originality  I'd rather put couple of rear mounted turbos to that anyway..... Great body anyhow. I'm lucky again to live so far from that. Needless to say, I'm poor too
|
|
By junkyardjeff - 14 Years Ago
|
|
I would love to have it but way too much money for me.
|
|
By mctim64 - 14 Years Ago
|
|
Here's something else that Lon sent me the link for, any of you guys seen this before? Pretty neat but againe a little pricey. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=380301697302&ssPageName=ADME:B:EF:MOTORS:1123
|
|
By The Master Cylinder - 14 Years Ago
|
A little pricey? Am I reading it right, that it is not even original? "Needless to say the housing was not cheap to make. It is very close to the original."
Not to mention that appears to be a Mechanical Fuel Pressure Gauge routed to the interior. Doubt if that would pass tech...
|