|
By Maybelle lee - 14 Years Ago
|
|
i have recently discovered that my flywheel was installed incorrectly by the guy who rebuilt my 292, and therefore was bent out of wack. so, i am needing to replace it! but, i am having trouble finding a replacement flywheel for my 1958 ford custom 300. i have been told that this flywheel was only made for a period of 2 years for my specific car/model. i have called EVERYWHERE AND EVERYONE and cannot locate even a used one from a tranny shop! my car is in southern california, any suggestions on where i can find this phantom flywheel?! thanks so much! Maybelle
|
|
By pegleg - 14 Years Ago
|
|
Try the classified section, and I assume this is for an automatic?
|
|
By carl - 14 Years Ago
|
|
Is the trans a 2 speed automatic,if it is i have a 292 engine and 2 speed auto trans that came out of a 59 Edsel,the flywheel might be the same as your 58 but dont know for sure Carl Lynn
|
|
By marvh - 14 Years Ago
|
Check the flywheel convertor's mounting holes.
V8 Cruise-o-matics convertors had four mounting holes and the V8 aluminum 2 spd Ford-o-matic convertors had 3 mounting holes.
Both V8 flywheels are same diameter with 148 teeth.
|
|
By Maybelle lee - 14 Years Ago
|
|
yes, and i will check classifieds. thanks!
|
|
By Maybelle lee - 14 Years Ago
|
|
yes, its a 2 speed auto! where are you located?!!
|
|
By Maybelle lee - 14 Years Ago
|
it has 3 mounting holes.thanks for the help 
|
|
By carl - 14 Years Ago
|
|
The trans. is still atached to the motor give me a couple days to pull it apart and check it Carl Ohio
|