|
By jonas winslo - 13 Years Ago
|
I just got my ball joints from Kanter and while the lower went in w/o a problem the upper is off on one bolt hole by almost an eigth of an inch. Has any one else had problems fitting their components? In this case it is on a 56 TBird. I will be approaching their customer service, but I have read some posts(at other sites) regarding their CS that do not bode well.
Any clues from you guys who have done this procedure before are appreciated.
|
|
|
By The Master Cylinder - 13 Years Ago
|
IMO you're first mistake was dealing with Kanter. I have had more than my share of problems with them in the past, from receiving wrong parts to not receiving parts at all. Now refuse to deal with them.
good luck with their customer service with your problem. Sorry couldn't be more positive.
|
|
By Joe 5bird7 - 13 Years Ago
|
|
It's been 10 yrs ago or so, but I got a "complete" front end kit from Kanter (included ball joints) for my 57 Bird, and everthing fit and works as it should. That's my only experience with them.
|
|
By drof75 - 13 Years Ago
|
|
I got my complete front end kit from kater 2 yrs ago and there are at least 2 ball joints and 4 control arm bushings bad. Good luck
|