Profile Picture

Mallory Dual Point

Posted By MoonShadow 8 Years Ago
You don't have permission to rate!
Author
Message
MoonShadow
Posted 8 Years Ago
View Quick Profile
Supercharged

Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)Supercharged (7.6K reputation)

Group: Forum Members
Last Active: Yesterday
Posts: 4.6K, Visits: 37.8K
Guys I have a Y-Block Mallory dual point up on EBAY. It has a vacuum port on the side and some sort of contact pad behind it. I've never seen one of these before. I was told that some of the Mallory's had a vacuum advance system. I'm wondering if it delays the mechanical advance until vacuum is up enough to pull the pad away from the advance plate. Total guess! Anyway take a look at my listing. I'd prefer to sell to one of the Y's guys if possible. Chuck
http://www.ebay.com/itm/332155733571?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
http://forums.y-blocksforever.com/uploads/images/02dfed30-6eac-42d6-9748-c60e.jpg


Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire
Reply
DANIEL TINDER
Posted 5 Years Ago
View Quick Profile
Supercharged

Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)Supercharged (2.3K reputation)

Group: Forum Members
Last Active: Yesterday
Posts: 1.7K, Visits: 144.6K
Still looking for a vintage Mallory service recommendation (?).
BTW: Looks like orig. OEM tach cable should work.  Also, though not experiencing any engine misfires, my Motorcraft plug wires ARE over 15 yrs. old.  Not so much the expense of replacement concerning as the labor involved (just to test the Mallory). I might buy a new set though to cut the ends off of, and jerry rig their temporary installation (leaving the old ones in position), then put them away along with the Mallory until bigger carb/manifold combo finally gets installed.

6 VOLTS/POS. GRD. NW INDIANA



Reading This Topic


Site Meter