Profile Picture

Cleaning up an intake manifold???

Posted By Deyomatic Last Year
You don't have permission to rate!

Cleaning up an intake manifold???

Author
Message
Deyomatic
Posted Last Year
View Quick Profile
Supercharged

Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)Supercharged (853 reputation)

Group: Forum Members
Last Active: 11 minutes ago
Posts: 293, Visits: 2.4K
I got a good deal on an ECZ-9425B manifold and I'm in the process of getting it prepped for paint to put it on after smoothing out the venturi holes a little...

Is there something I can soak it in that will get rid of the rust in the thermostat area, as well as any other surface rust as well as the heat riser ports?

Thanks.

Threaded View

Threaded View
Forum Post Cleaning up an intake manifold??? By Deyomatic ( Last Year )
Forum Post I know that I will probably get some negative comments in response to... By alanfreeman ( Last Year )
Forum Post Depending upon the amount of rust, you might consider having it media... By 55blacktie ( Last Year )
Forum Post Another good idea would be to use electrolysis. For something as small... By Daniel Jessup ( Last Year )
Forum Post Thank you...three great ideas. Daniel- do you think the electrolysis... By Deyomatic ( Last Year )
Forum Post The electrolysis works well if you are willing to be patient with it.... By Daniel Jessup ( Last Year )
Forum Post I may just try to have it blasted somewhere. It's not as crusty as I... By Deyomatic ( Last Year )
Forum Post I have sandblasted both cast iron intakes and aluminum intakes before... By Joe-JDC ( Last Year )
Forum Post Thanks Joe, Should I get 80 grit or 120 aluminum oxide…or something... By Deyomatic ( Last Year )
Forum Post Which ever one you have, adjust the pressure to get a rough texture on... By Joe-JDC ( Last Year )
Forum Post I will try the 120 then. Thanks again. The only paint “quality” I... By Deyomatic ( Last Year )
Forum Post You'll need to remove oil/grease, etc. before it's media blasted;... By 55blacktie ( Last Year )
Forum Post If media blasting is done properly, it will remove all greases,... By Joe-JDC ( Last Year )
Forum Post HMMMM... Could I hit the suspect areas with brake cleaner or even a... By Deyomatic ( Last Year )
Forum Post When my heads came back from the machine shop, I thought they were... By 55blacktie ( Last Year )
Forum Post Thanks for the tip...I had planned on using acetone but I do have a... By Deyomatic ( Last Year )
Forum Post I used a cheap brass-wire brush for scrubbing, cheap paint brushes for... By 55blacktie ( Last Year )
Forum Post I plan to do the same with a manifold that I just picked up. I can... By Skyliner57 ( Last Year )
Forum Post Are you retaining the original heat-riser choke? By 55blacktie ( Last Year )
Forum Post The heat riser tube replacement is a 10 minute job with the manifold... By cokefirst ( Last Year )
Forum Post I had not planned go remove, the car starts extremely well. I see... By Skyliner57 ( Last Year )
Forum Post You have a 56 FORD and you are putting a 1957 ECZ-B intake on it? Each... By KULTULZ ( Last Year )


Reading This Topic

Site Meter