I have a 4 speed behind my 292 that is out of a 62 or 63. I bought a speedo cable (56 won't work) but need idea of what gear to put on it. Not sure of rear gear. Car was originally auto but was converted to stick before I bought it.

Ol'ford nutCentral Iowa

56 Vic w/292 & 4 spd.

Ol Ford nut:

Determine what the rear axle ratio is.  Then buy a gear for a '62 with that, or at least close to, ratio.  Should get you in the ballpark.  You can vary the tooth count up or down if the first choice isn't satisfactory.

John - "The Hoosier Hurricane"

One of the problems with speedo gears is that ford used gears that had "teeth" that ran different directions. One determination may be on what side of the trans the gear was located on.

54 Victoria 312;  48 Ford Conv 302, 56 Bird 312
Forever Ford
Midland Park, NJ

Ol Ford nut:

Be sure to get the clip that holds the gear onto the cable stub, or you will end up with the gear in the bottom of the trans.

John - "The Hoosier Hurricane"

John, i found out about the clip the hard way, i made a clip from a loop from accelerator spring, it is still working! regards bill.

  AussieBill            YYYY    Forever Y Block     YYYY

 Down Under, Australia