|
By junkyardjeff - 14 Years Ago
|
|
Since I was taking some parts off a 56 for a friend I grabbed a complete set of plug wire holders since I dont think both of my motors have a complete set of holders,this car had two flat 4 wire rubber holders with little straps around them for the wires on the drivers side of the motor and since its been so long since I seen them is this correct.
|
|
By Barry L - 14 Years Ago
|
|
Hi Usually there are flat four holders at the back of the motor and square four holders under the exhaust manifolds at the rear, bottom corners of the heads. Check out page 26 of this on line catalog www.prestigethunderbird.com Barry
|
|
By Duck - 14 Years Ago
|
If I understand you correctly, yes, those be them... 
|
|
By junkyardjeff - 14 Years Ago
|
|
I am suprised they were still on the car due to being a pain to reinstall with new wires,the last set I installed took me about 3 hours and will buy good wires and install when the motor is on the stand or before the manifolds go on.
|
|
By Y block Billy - 14 Years Ago
|
|
What do yopu mean a pain to install? If you are still doing your own work you must be a contorsoinist also?
|
|
By paul2748 - 14 Years Ago
|
If your using the 7mm or 8mm wire on new holders, these can be a real hassle getting them through the holes or, if you take them apart to insert the wires, the clips are very hard to close up. I did it ok with one set because, I think, they were originl holders. Not as successful with a reproduction set, I ended up making new inserts out of nylon in place of the rubber.
These were for new wires, with one end unfinished.
|
|
By gritsngumbo - 14 Years Ago
|
Barry L (3/19/2011)
Hi Usually there are flat four holders at the back of the motor and square four holders under the exhaust manifolds at the rear, bottom corners of the heads. Check out page 26 of this on line catalog http://www.prestigethunderbird Barry
I couldn't get the link to work. I would like to look at the diagram. Is it just me and my computer?
|
|
By paul2748 - 14 Years Ago
|
|
wouldn't work for me either - just type in the url, it works. you can leave off the http//
|
|
By junkyardjeff - 14 Years Ago
|
|
The last time I put plug wires on the original 272 I used cut to fit wires and will do the same when the 292 goes togather.
|
|
By Barry L - 14 Years Ago
|
|
Hi I've edited the above link in my first post..should work now. Barry
|