I have read in my manual the torque specs for the head but see nothing in there for the rod and main bearing end caps nuts is there a sequence that you have to work up to? Does anyone have this info?

Ford manuals should have those specs..what are you using?


Paul

Gere you go....

http://yblockguy.com/techtips/yblocktorquetable.html

Best regards Jimmy Carlsson, Fagersta (Sweden) Ford F100 1956, 272 , 3 manual with OD
Follow my restoration on http://dinnerhillspeedshop.blogspot.se/

I finally found it in the book it is 80-90 should I go with that or the numbers of 95-105 which I have seen elsewhere

If the block is a 312, I'd go with the lower numbers, especially on the mains. However, this is based on observations from this site & rebuild write ups etc.. I'm not an engine rebuilder..


Paul