Flat cam again???

Posted By Y block guy 10 Years Ago

You don't have permission to rate!

Author	Message
Y block guy	Posted 10 Years Ago
Supercharged Group: Forum Members Last Active: 5 Years Ago Posts: 42, Visits: 1.4K	I'm trying to figure out why I keep having cam issues. Both cams(2) have gone flat on #6 cyl. Ex. Don't know why, ANY suggestions would be greatly appreciated. Engine a 312 w/ported ECZ-g heads,Mummert spec'ed cam
	Reply Quote

Threaded View

Flat cam again??? By Y block guy ( 10 Years Ago )

Also check that guide to see if it is too tight. You should be able to... By RB ( 10 Years Ago )

[quote][b]Y block guy (2/11/2015)[/b][hr] Thanks for the reply, I'll... By Ted ( 10 Years Ago )

[quote][b]Y block guy (2/14/2015)[/b][hr] Both cams and lifters were... By Ted ( 10 Years Ago )

I would take a very hard look at the guide clearance on the exhaust... By RB ( 10 Years Ago )

What does the lifter look like? Is it spinning in the bore? What... By mctim64 ( 10 Years Ago )

Adding to what Royce brings up, if the cylinder heads have had bronze... By Ted ( 10 Years Ago )

And those clearances (new) should be? By pegleg ( 10 Years Ago )

[quote][b]pegleg (2/14/2015)[/b][hr] And those clearances (new) should... By Ted ( 10 Years Ago )

Pushrod alignment within the holes in the heads is critical on the Y... By Ted ( 10 Years Ago )

I'm not sure most shops will be able to get to the tenths. Probably... By pegleg ( 10 Years Ago )