Intake manifold

Posted By Kahuna 10 Years Ago

You don't have permission to rate!

Author	Message
Kahuna	Posted 10 Years Ago
Supercharged Group: Forum Members Last Active: 6 Years Ago Posts: 471, Visits: 2.4K	Is the original T-Bird 2x4 manifold aluminum or cast iron? Thanks Jim
	Reply Quote

Threaded View

Intake manifold By Kahuna ( 10 Years Ago )

The '57 'E' code manifolds used on passenger cars and 'Birds was... By NoShortcuts ( 10 Years Ago )

Mine is date codes for 57 and it is aluminum. Rowen By Rowen ( 10 Years Ago )

A pic o my new engine. Just a mock up so... By Rowen ( 10 Years Ago )

Rowen, it looks great By Kahuna ( 10 Years Ago )

Food for thought, Rowen. Consider assembling your engine with a... By NoShortcuts ( 10 Years Ago )

Drove the 2x4s for almost 40 years. They bogged and loaded at idle... By famdoc3 ( 10 Years Ago )

I have been running the E setup since 1968. Always carry a fire... By slumlord444 ( 10 Years Ago )

Wasn't there an article on here about over tightening the center... By MoonShadow ( 10 Years Ago )

I have a LOT of experience with these "Teapots", "Pressure Cooker",... By Kahuna ( 10 Years Ago )

Sal built both my carbs as a pair. I have all confidence that when the... By Rowen ( 10 Years Ago )

I am hoping someone could help me.... By efrain ( 9 Years Ago )

[quote][b]efrain (4/18/2016)[/b][hr] Any suggestions on where to get... By Ted ( 9 Years Ago )

Oddly enough, I had the same problem with Best gaskets but on... By paul2748 ( 9 Years Ago )