Thanks so much, Bill
regards
Jim

I  have the original Ford instructions for installing seat belts in 1955 and 1956 passenger and Thunderbird cars.  They are posted on my website:

https://classiccarradiodoctor.com/fordseatbelts.htm

That should be the info you need.

Good luck,

Bill Abate
wabateATverizonDOTnet

the washers are just sandwiched no welds 

The washer is just sandwiched no welds 

I installed Seat belts in mine without benefit of the Illustrations. Looking at the Illustrations now I am not far off correct Locations. I used Gr. 8 Nuts, Bolts,
and correct Size Flat Washers with a second oversize Flat washer on the underside of Floor. I assume they are as well installed as the original would have been. Hope I never have to find out. I also installed Rear Seat Belts.

  

Hi all

a fellow y-blocker sent this to me some time ago - it's seat belt instructions for '52-'56 Fords.  The resolution of the document isn't great, but hopefully it will help.  Let me know if the document does not come through and I can email it to you.


MplsMike
'56 Parklane
Minneapolis, MN

Thanks Glasstop. Is the 2-1/2" round washer attached to the body floor in anyway( spotweld) or is it part of the sandwich of the attachment bolt? Thanks.

56 Vic, B'Ville 200 MPH Club Member, So Cal.

I checked my 1956 Club sedan the holes for the seat belts are located as follows,on the right side of the car  7 1/2 back from inches from the rear hole where the seat would mount is  one hole, 15 inches across would be the second hole. Under the car there is a 21/2 inch washer on the bolt that is put through the floor. The washer is about 3/16 thick. I hope you understand its a bit hard for me to explain . 

Really appreciate it, 55 glass
Thanks 
Jim

Hello I have a 1956 Club Sedan with factory seat belts , it has the safety package with the padded dash . I raining here but I will go out in the morning and try to describe where the factory put them .