My contact info is at  www.eatonbalancing.com  .  Email at that site is also working again.  Thanks.

Lorena, Texas (South of Waco)

What is your mailing address Ted? I'll help out a little.

 

Paul,

Boonville,MO

Pete.  The Cain intake manifold showed up and in good condition. I did send you a snail mail note not long after receiving it but you’ve likely not received that note yet.  First impressions are it’s a high rpm piece and will not perform well in the lower rpm’s but I’ll be dynoing a Y within the next week which will be an opportunity to run the first test on it.  I’ll send you the dyno sheets comparing it to the Blue Thunder after this upcoming dyno session is complete which will document the manifold’s performance against another.  Thanks again for sending the manifold.

 

John.  There have been checks and some cash rolling in and I’m keeping a list of all that contribute.  I sent out a newsletter a couple days ago to all that have contributed so be looking for that in the mail.  Thanks again to all that have contributed or about to do so.

Lorena, Texas (South of Waco)

Also, Ted, how is the financial help coming along?  We need to back you on this.  We tried a couple of times to let Jim accept our help, and he refused it.  Now we can help you instead, and we need to do that. 

John - "The Hoosier Hurricane"

Hi Ted, has the manifold turned up yet? any first impressions?

Pete, one of the Aussie mob. Beechworth, Victoria60 F100 Panel Van, Y-block. 65 Galaxie Country Sedan 390

Great. Now I wonder if I should actually install all the alum. Rebop parts I accumulated, or save them for posterity as "new-in-box" museum collectables.

6 VOLTS/POS. GRD. NW INDIANA

AAHHH  JEEEEZESS   Frank, so sorry to hear. Thank God I have your timing cover, water pump, and Thermo cover.  THANK You for your concern about the quality of you parts.  Everything has been First Class.  Again Thanks  God Bless   Eddie

Eddie

Lake Forest, Ca. 92630

Rebop is pretty much history. The sales fell off a cliff last year, and I had a problem finding another foundry for the aluminum parts. Went through three with very poor results. Lousy quality, and deliveries, but high prices. I have found a foundry that will and can make the parts, but still don't see enough sales to warrant the investment in time and money to restart it. I can't afford to continue to subsidize this, have to support a familty and eat first.

Frank/Rebop

Bristol, In ( by Elkhart) 

Pete, these manifolds etc were cast from anything alloy that would melt and often were put on boats due to the open runner design, i have ran them in the days when they were only 4bbl intake available here, as there wasnt anything else to compare them to, they seemed to go ok. I have several and must say, that one looks nice. We often joked they would turn red when you put your foot down as the fuel was coming through the casting, he, he. Regards bill.

  AussieBill            YYYY    Forever Y Block     YYYY

 Down Under, Australia

O.K. Ted it's on it's way, jeez I hope it's not a dud.

Pete, one of the Aussie mob. Beechworth, Victoria60 F100 Panel Van, Y-block. 65 Galaxie Country Sedan 390