|
Group: Forum Members
Last Active: Last Year
Posts: 512,
Visits: 1.7K
|
I think the book calls for 55 to 75 ft lbs torque. I usually tighten them, bounce the front end a couple of times and check them again.
Kenneth
Fredricksburg, Texas
|
|
Group: Forum Members
Last Active: 12 Years Ago
Posts: 322,
Visits: 1.2K
|
I have arms in correct position, just want to verify 50# is correct.
Ol'ford nutCentral Iowa
56 Vic w/292 & 4 spd.
|
|
Group: Forum Members
Last Active: Last Month
Posts: 3.7K,
Visits: 32.6K
|
You may also notice it says do the final tightening with the car down on the ground with A-arms in regular position not hanging down.
 
|
|
Group: Forum Members
Last Active: 12 Years Ago
Posts: 322,
Visits: 1.2K
|
Getting ready to have front end aligned and remembered that I had to torgue the lower a-frame bolts now that car is at normal height. In reading my manual it says 50# if I read it correctly. Is this correct? This is the 4 bolts that go into the front and rear crossmember. Thanks!
Ol'ford nutCentral Iowa
56 Vic w/292 & 4 spd.
|