Weld a bell housing?

Posted By CodyConley 15 Years Ago

You don't have permission to rate!

Author	Message
CodyConley	Posted 15 Years Ago
Normally aspirated Group: Forum Members Last Active: 13 Years Ago Posts: 25, Visits: 92	Is it possible to weld a bell housing? Are these things cast iron? If so, tig, mig, rod type. It appears my OG bell was smashed. It was brazed back together. Over 20 pieces, no kidding!!
	Reply Quote

Threaded View

Weld a bell housing? By CodyConley ( 15 Years Ago )

It is possible to weld or braze cast iron.
They all involve... By rick55 ( 15 Years Ago )

I probably should have mentioned in my earlier reply that you need to... By rick55 ( 15 Years Ago )

Probably going to ruffle some feathers with this one, but you can... By badnewsdan ( 15 Years Ago )

[quote][b]badnewsdan (1/30/2010)[/b][hr]Probably going to ruffle some... By Ted ( 15 Years Ago )

No ruffled feathers here either.I've been stick welding cast iron for... By PWH42 ( 15 Years Ago )

Pre-heat and wire feed, that's what I do when modifying for the T-5,... By mctim64 ( 15 Years Ago )

Did that on a 57 intake and it worked out fine. And it's still... By speedpro56 ( 15 Years Ago )

Cody, I sent you a pm about the bellhousing. Butch By Butch Lawson ( 15 Years Ago )

My left side exhaust manifold is welded. It was broke completely in... By ejstith ( 15 Years Ago )