Hi Guys. I probably have a dumb question but I in the process of finishing assembly on my new 292 for my 56 F100.



I have a C2AE block which does not have a hole for a draft tube on the side of the block. Is it best to get a valley cover that is set up for a rear draft tube or none at all.



Have finned aluminum Moon valve cover with no breathers so only point would be oil fill tube. ( I am not so comfortable with setting up a PCV )



any advice would be greatly appreciated



I will post some picture next wee to get some input.

you must have a draft tube or pcv.

Howdy,





I have my draft tube hole covered. It's far better (and cleaner) to install a PCV on the engine.





Cheers,





Rick


-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1955 F-600/272/E4OD// Disclaimer: No animals were injured while test driving my F-600 except the ones I ran over intentionally!

---------------------
This post was created using OpenSuSE Linux x64 and Firefox