Profile Picture

External Oiler for 312 Y block

Posted By SurfMerc 15 Years Ago
Rated 5 stars based on 1 vote.

External Oiler for 312 Y block

Author
Message
SurfMerc
Posted 15 Years Ago
View Quick Profile
Normally aspirated

Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)

Group: Forum Members
Last Active: 13 Years Ago
Posts: 35, Visits: 224
My 56 Monterey wagon has the original 312 with no recent rebulit that I can see. I want to install a external oiler which I have to prolong its original condition. Has anyone ever installed an external oiler? I am not sure which rocker arm caps to install the oiler caps. The caps that have the overflow tube seems to me to be the ones because there is a hole that goes into the rocker arm tube unlike the other caps. Any suggestions?

Thanks AR


Threaded View

Threaded View
Forum Post External Oiler for 312 Y block By SurfMerc ( 15 Years Ago )
Forum Post You don't say, are you experiencing a lack of oiling up top on both... By PF Arcand ( 15 Years Ago )
Forum Post No oil coming out of the overflow tubes. Very little oil at the rocker... By SurfMerc ( 15 Years Ago )
Forum Post Try to diagnose the problem and see if there is a real problem and a... By mctim64 ( 15 Years Ago )
Forum Post You posted while I was typing. :P If you are getting some oil up... By mctim64 ( 15 Years Ago )
Forum Post Good point! I will take your advice and run with it! Thanks again... By SurfMerc ( 15 Years Ago )
Forum Post I agree.If you take it apart you will likely find the shafts plugged... By oldcarmark ( 15 Years Ago )
Forum Post Thanks for all your input! This was my first time on the forum and I... By SurfMerc ( 15 Years Ago )
Forum Post Welcome to the forum by the way! ;) By mctim64 ( 15 Years Ago )
Forum Post Hi SurfMerc, Welcome to the forum. To elaborate a little about the... By Nick Brann ( 15 Years Ago )
Forum Post I had the same problem with my 292. I removed the rocker assemblies,... By awhtx ( 15 Years Ago )
Forum Post Thanks for your comments! I will disassemble, clean and reassemble and... By SurfMerc ( 15 Years Ago )
Forum Post One last note, I stand to be corrected, but I believe the replacement... By PF Arcand ( 15 Years Ago )
Forum Post I might have posted on the wrong subject but the problem remains the... By green-beret ( 12 Years Ago )
Forum Post In the latest issue of Y-Block Magazine (Issue #116), Jerry... By Ted ( 12 Years Ago )
Forum Post In response to Mr. Green-Beret, I'm assuming that the engine had been... By Fairlane Mike ( 12 Years Ago )
Forum Post I seem to have the opposite problem! Removed the l/h valve cover to... By slick56 ( 12 Years Ago )
Forum Post If you are getting TOO much oil flow you can tap the passage in the... By oldcarmark ( 12 Years Ago )
Forum Post [quote][b]slick56 (7/14/2013)[/b][hr]I seem to have the opposite... By Ted ( 12 Years Ago )


Reading This Topic

Site Meter