I have mine in the same location as Alan, much cleaner installation than in the intake manifold.

BOB

thats what I was trying to find. now that I know what im looking for it looks like i can get them local in Equus brand. Thanks

Kenny  Onalaska, Texas

Kenny, Errata sheet to my first reply...The autometer fitting is a brass bushing, Look it up on "Summit" to see if that's what you are looking for. i.e., if it will fit your mechanical sensing bulb..You are right when you say the intake manifold is 3/8 NPT..Good luck

1957 T'Bird, 312, 4 speed B-W , T-10

Purchase AutoMeter P/n 2263 from Summit Racing for $6....That should do it, it worked for me!

1957 T'Bird, 312, 4 speed B-W , T-10

my mistake. mechanical guage uses 1/2" npt.  3/8" npt on the intake

Kenny  Onalaska, Texas

I have my mechanical temp gauge mounted at the fitting at the rear of the head, drivers side. Same place it was originally, only electric. Heater sender then stays the same.

       A  L  A  N   F  R  A  K  E  S   ~  Tulsa, OK    

It's probably 1/4" and 3/8" pipe threads. Can you drill and tap the intake?


Lawrenceville, GA

The mechanical water temp guage uses a 3/4" fitting. The hole in the intake behind the thermostat is 1/2". My heater hose also needs to come from this location. Is there any solutions that dont look awful?

Kenny  Onalaska, Texas