Profile Picture

Dwell Adjustment

Posted By SurfMerc 15 Years Ago
You don't have permission to rate!
Author
Message
SurfMerc
Posted 15 Years Ago
View Quick Profile
Normally aspirated

Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)Normally aspirated (45 reputation)

Group: Forum Members
Last Active: 13 Years Ago
Posts: 35, Visits: 224
Been trouble shooting a rough idle, low performance problem for a long while on my 312 in a 56 Merc with stock distributor. I hooked up a dwell, RPM.volt meter and noticed that the dwell increases as I throttle the carb. Is this indicating a bad distributor? Also, The volt meter is reading 7 volts. What should this reading be and is 7 a low reading?

Thank You - AR


Threaded View

Threaded View
Forum Post Dwell Adjustment By SurfMerc ( 15 Years Ago )
Forum Post It is most likely wear of the bushing allowing the clearance between... By GREENBIRD56 ( 15 Years Ago )
Forum Post Volt meter had one wire at the distributor side terminal of the coil... By SurfMerc ( 15 Years Ago )
Forum Post Not too bad then - that test point is on the "down side" of the wiring... By GREENBIRD56 ( 15 Years Ago )
Forum Post If you do get a later distributor you will have to update the manifold... By Y block Billy ( 15 Years Ago )
Forum Post Y-Block Bill! Even adding just the later distributor will make a big... By oldcarmark ( 15 Years Ago )
Forum Post If I remember correctly, Ted said in another thread that you can use... By paul2748 ( 15 Years Ago )
Forum Post You cant use the one that worked with the stock distributor because... By oldcarmark ( 15 Years Ago )
Forum Post Your right! The original Carter thats on the engine has a vacuum port... By SurfMerc ( 15 Years Ago )
Forum Post Don't avoid the use of the later mechanical advance style distributor... By GREENBIRD56 ( 15 Years Ago )
Forum Post [quote][b]GREENBIRD56 (9/21/2010
"the torque advantage of the...
By DANIEL TINDER ( 15 Years Ago )
Forum Post Daniel - Isn't the dual diaphragm "Load-O-Matic" the one we were... By GREENBIRD56 ( 15 Years Ago )
Forum Post Actually as I recall they used the loadomatics on the 144-250 6... By oldcarmark ( 15 Years Ago )
Forum Post [quote][b]GREENBIRD56 (9/21/2010) "maintenance difficulties would be... By DANIEL TINDER ( 15 Years Ago )
Forum Post Actually Daniel I have to disagree with part of your statement.I... By oldcarmark ( 15 Years Ago )
Forum Post Steve; Re the Load -O-Matic distributors, a small correction, they... By PF Arcand ( 15 Years Ago )
Forum Post Mark,

Just going by my own experience. Original Loadomatic...
By DANIEL TINDER ( 15 Years Ago )


Reading This Topic


Site Meter