Profile Picture

flywheel swap

Posted By mercman-49 14 Years Ago
You don't have permission to rate!

flywheel swap

Author
Message
mercman-49
Posted 14 Years Ago
View Quick Profile
Normally aspirated

Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)Normally aspirated (25 reputation)

Group: Forum Members
Last Active: 12 Years Ago
Posts: 25, Visits: 346
I would like to find out if a 239 flywheel will work on a 292.Ihave a 292 with a 11 inch bolt pattern,i;m wanting to use a 10 inch clutch.I have a flywheel from a 239 but all the bolt holes are the same size,I don't know about the balance,thanks                                                                          Darrell Gipson,Mobile,AL

Darrell Gipson Ala.Gulf Coast

Threaded View

Threaded View
Forum Post flywheel swap By mercman-49 ( 14 Years Ago )
Forum Post As far as I know, all YBlock flywheels were zero balance By paul2748 ( 14 Years Ago )
Forum Post I have been in my shop 3 hrs tring to line up bolt holes in flywheel... By mercman-49 ( 14 Years Ago )
Forum Post It will only go one way. You can usually see an impression from the... By MoonShadow ( 14 Years Ago )
Forum Post I tried lining up the two flywheels and one hole off is the best it... By mercman-49 ( 14 Years Ago )
Forum Post If you were trying to line up the flywheels with each other back to... By Hoosier Hurricane ( 14 Years Ago )
Forum Post 239 and 292 flywheels interchange at the crankshaft. There is... By Ted ( 14 Years Ago )
Forum Post Ted; I have a two-part question here; First, I have two flywheels I'm... By Rono ( 14 Years Ago )
Forum Post [quote][b]Rono (2/21/2011)[/b][hr]Ted; I have a two-part question... By Ted ( 14 Years Ago )
Forum Post Reasons for balancing a flywheel that is balanced from the factory:... By charliemccraney ( 14 Years Ago )
Forum Post I found the problem was one bolt hole in the crankshaft had been... By mercman-49 ( 14 Years Ago )
Forum Post I am installing a used resurfaced flywheel to my 312. Purchased clutch... By YBLOCKEREDH ( 9 Years Ago )
Forum Post Thanks Charlie, It was very good condition. I watched the resurface... By YBLOCKEREDH ( 9 Years Ago )
Forum Post [quote][b]YBLOCKEREDH (12/23/2016)[/b][hr]I am installing a used... By Ted ( 9 Years Ago )
Forum Post Thank you Ted and Charlie, that looks like exactly what has happened,... By YBLOCKEREDH ( 9 Years Ago )
Forum Post The flywheel is drilled such that it will only go on one way. If it... By charliemccraney ( 9 Years Ago )
Forum Post The holes aren't tapered. Do you have original bolts to compare the... By charliemccraney ( 9 Years Ago )


Reading This Topic

Site Meter