Yes.  Four lobe cam point setting adjustment would be 0.020” or 34° dwell for each point set.

Lorena, Texas (South of Waco)

Thanks for the help guys.

doesn't it make a difference if it's a 4 lobe cam instead of 8 lobe?

 lincoln/merc. y-blocks &mel's                                                               bucyrus, ohio.

Welcome to the site!

 

Unless there’s a tag on the outside of the Mallory distributor saying otherwise, for an eight cylinder eight lobe Mallory distributor set each breaker point gap setting at 0.018”.  If using a dwell meter, then only re-adjust the breaker point set that opens first to make total time dwell adjustments.  Total dwell for this particular application when checking it with a dwell meter should be ~34° +/- 2°.  Unless you are readjusting the set of points that opens second, the ignition timing itself is not expected to change.  But to be on the safe side, be sure to double check the ignition timing anytime point gaps are being fiddled with.

Lorena, Texas (South of Waco)

I assume the OEM factory spec. for a single point unit should be the minimum to prevent burning/arcing? The added dwell inherent with dual points would likely allow more latitude for the maximum gap setting (compared to single points). Unless there is something unique about Mallory's design/ equipment.....?

6 VOLTS/POS. GRD. NW INDIANA

Hi guys,  

           This is my first post here and it's not going to be my last. I am just trying to set the points gap in my dads Mallory dual point dizzy. Can anybody reccomend what the point gap should be?

Thanks in advance.