|
Group: Forum Members
Last Active: 2 Weeks Ago
Posts: 452,
Visits: 24.4K
|
Hey Yall,
I'm doing a little measuring to align my driveshafts. now that I know the trans won't interfere with the cab...... Can't do it until I get the angle on the engine. Can't get the angle on the engine until I set it by welding the trans mount together.
Can't well the trans mount together unless I know the optimum angle of the Y-block dangle!
So, what should it be? I'm going to "guess" at 3 degrees (down) Am I close?
Cheers,
Rick
1955 F-600/272/E4OD// Disclaimer: No animals were injured while test driving my F-600 except the ones I ran over intentionally!
---------------------
This post was created using OpenSuSE Linux x64 and Firefox
|