I have been working on a 55 crown.  Today i drove it out of my shop for a test drive ..Stopped to close the door , started the car and could not shift into low  ...After checking everthing under the hood, looked ok ,  jacked the car up and went under the car.  about that time a friend came by and had him in the car to work the clutch.....adjusted the the clutch rod , started the car and now the clutch would not dis-engage....back under the car again , pulled the dust cover ,    found problem......the clutch fork will not stay on the pivot points..  They seem very small, about the size of a beebee.    anybody run into this problem befor ?  I hate to pull the trans out ,  i put it together on the floor and installed the motor and trans together....Let me know of any ideas.....Thanks in advance....Sam.....................Florida ...west central

56 victoria