OK, here are some pictures of the tool, it is sold by Snap-On part# S-8672. This is an old tool so I don't know if the still stock it, but I would think some local shop would have something like it.

   God Bless.   Tim                           http://yblockguy.com/

350ci Y-Block FED "Elwood", 301ci Y-Block Unibody LSR "Jake", 312ci Y-Block '58 F-100, 338ci Y-Block powered Model A Tudor

tim@yblockguy.com  Visalia, California    Just west of the Sequoias

Y-Guy Tim I appreciate the info on the T-5 bushing . Just

post that picture at YOUR leisure.....

Thanks Bill.

Bill

Pelham,Al

I just replaced the bushing in mine using an old tool that slips down the tailshaft and locks onto the bushing, then you draw it out like a damper puller. The tool was sold by Snap-On, I'll try to post a picture later, It's at the shop 20 miles away and it is Sun. 

No, You don't have to remove the tailshaft housing.

   God Bless.   Tim                           http://yblockguy.com/

350ci Y-Block FED "Elwood", 301ci Y-Block Unibody LSR "Jake", 312ci Y-Block '58 F-100, 338ci Y-Block powered Model A Tudor

tim@yblockguy.com  Visalia, California    Just west of the Sequoias

Y-Guys Not an original "Y" part,but a little help from my friends;

The rear bushing, in my T-5, needs replacing. does the rear

tailhousing have to come off to do it? or ?

Thx in advance

Bill

Bill

Pelham,Al