I purchased a y block that was bored out .60 over, decked and the crank is .10 over. I got everything with the deal minus the oil pan,heads, vallet cover and some other odds and ends. I started claning it today for assembly and I found a few issues that will be a big issue. Please tell me its not too bad. Here are the pics.

See the little ridges in cylinder three? You can feel them with your finger nail. Would it work to hone it?

Also where the rear main seal is a part of the casting has been broken off.

 

 

I seriously dont know what to do, Im pretty bummed out.

Fomoco Low Life