Ive tryed some of that stuff Ive put oil on it now and leting it soak I was thinking if the oil dont help I may try puting some heat on the block is that a bad i deal All of this stuff has ben siting for 35-40 years

86 mustang 351c

lt250/500r hybrid 4'' over swinger scr porting v2 reeds Q-pipe

West virgina

Itman: Penitrating oil and patience! Let it soak overnight & use the before mentioned methods. "Light" tapping can also be helpful.

Paul

I've had real good luck using a band type oil filter wrench and penetrating oil on 'em.... /Duck

BOO- YA!!!

Iam glad to see this post, Saves me from having to ask the same question. I guess after 40-50 years the dizzy wants to stay put..

WTB 1955 Courier emblems    Mark, Jefferson City Missouri

Wrap the dist housing with several wraps of heavy duct tape (90 MPH tape). Then try to move it back and forth with a pipe wrench while spraying with PB blaster or WD 40. Once you get it moving a few light taps with a plastic mallet should get it out.

Glen Henderson



Freedom is not Free

Letohatchee, AL

If you can get at it, I have found that light upward hits with a rubber mallet work quite well. Don't hit the vacuum canister, as tempting as it may be. It doesn't take much to brake it off.


Lawrenceville, GA

I have a couple stuck distributors Whats the best way of going about geting them out with out breaking them

86 mustang 351c

lt250/500r hybrid 4'' over swinger scr porting v2 reeds Q-pipe

West virgina