Profile Picture

squealing when letting off the accelerator

Posted By dmmats 15 Years Ago
You don't have permission to rate!
Author
Message
aussiebill
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)Supercharged (2.6K reputation)

Group: Forum Members
Last Active: 5 Years Ago
Posts: 1.8K, Visits: 11.4K
314 (6/16/2010)
your intake gasget is leaking.been there.its sounds like a kittel on boil.

Unless i missed it, what was the outcome of the squeal problem you 1st mentioned, thanks.Wink

  AussieBill            YYYY    Forever Y Block     YYYY

 Down Under, Australia

314
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)Supercharged (430 reputation)

Group: Forum Members
Last Active: 7 Years Ago
Posts: 287, Visits: 1.7K
your intake gasget is leaking.been there.its sounds like a kittel on boil.
Timbo from Mempho
Posted 15 Years Ago
View Quick Profile
Normally aspirated

Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)Normally aspirated (46 reputation)

Group: Forum Members
Last Active: 12 Years Ago
Posts: 42, Visits: 1.2K
I've had a distributor bushing "squeal like a stuck hawg" and oiling it didn't help.
Ted
Posted 15 Years Ago
View Quick Profile
Co-Administrator

Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)Co-Administrator (13.3K reputation)

Group: Administrators
Last Active: Yesterday
Posts: 7.4K, Visits: 205.7K

Vacuum leak?  You might try unplugging the vacuum hose connection at the engine and plugging it temporarily.  The heater control valve at the intake can also be a likely suspect if it’s still in place.

Lorena, Texas (South of Waco)


Hoosier Hurricane
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)Supercharged (5.0K reputation)

Group: Moderators
Last Active: 8 hours ago
Posts: 3.7K, Visits: 322.9K
Check to see if the ring on the damper has slipped back and is rubbing on the front mount.

John - "The Hoosier Hurricane"
http://www.y-blocksforever.com/avatars/johnf.jpg
rick55
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)Supercharged (658 reputation)

Group: Forum Members
Last Active: 5 Years Ago
Posts: 550, Visits: 4.4K
If this problem only started after changing the generator and fan belt I would be looking at the bearings in the generator. try spraying a little WD40 around the ends of the generator, If it is the generator it is probably the front bearing.

The other thing it could be is a vacuum leak, but that sounds more like a whistle than a squeal. It will be evident when there is maximum vacuum usually when decellerating. It is easy to check, just spray the same WD40 along the edges of the manifold where it bolts to the head and also around the base of the carby. If there is a leak the engine will slow down or stumble. Make sure you don't spray near the intake of the carby as this will give a false diagnosis, but you will see what the effect of the WD40 is.

Hope this gives you somewhere to look.

Regards

Rick - West Australia
Do Y Blocks Downunder run upside down? Gravity Sucks!!
Gordie T
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)

Group: Forum Members
Last Active: 9 Years Ago
Posts: 140, Visits: 917
Exactly what I have had...any leak of rad fluid on the pulleys or fan belts will cause squeal under high torque...just starting...changing gears....



that is my experience...



Try and get it to repeat..under load...and spray water in a fine jet on the offending belt or pulley ...when it goes away....you've pinpointed the noise...



Gt

Gordie T           Long Point, Ontario
rgrove
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)Supercharged (576 reputation)

Group: Forum Members
Last Active: 4 Years Ago
Posts: 498, Visits: 3.5K
Wow...funny you post this.  My 56 sunliner has been doing the same thing lately.  If i let off the gas abruptly I get a brief, occasional squeal....

Im anxious to see what solutions get posted...

Ron Grove

Wauconda, IL

dmmats
Posted 15 Years Ago
View Quick Profile
First Time Poster

First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)

Group: Forum Members
Last Active: 15 Years Ago
Posts: 2, Visits: 18
Gordie,

No leaks recently and it is intermittent. I sprayed a lot of the Peratex stop squeak on it but it did not help. As I mentioned, it only happens when I let off the accelerator and it does not do it all the time.

Do you think the radiator fluid can cause intermittent squeals and only when letting off the gas. There is no squealing when accelerating. Thanks for your reply - it is driving me crazy.

Gordie T
Posted 15 Years Ago
View Quick Profile
Supercharged

Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)Supercharged (140 reputation)

Group: Forum Members
Last Active: 9 Years Ago
Posts: 140, Visits: 917
Dmmats...



Have you had a recent rad/fluid leak? Antifreeze causes your belt to squeal like a banshee...only when you want to be quiet...

Change the belt...wipe your pulleys...sound will go away.



Gt

Gordie T           Long Point, Ontario


Reading This Topic


Site Meter