It's a small block, or maybe big block... It's an other engine Duraspark with all of the guts removed.


Lawrenceville, GA

Charlie,





What distributor is that?









tnx/Rick


-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1955 F-600/272/E4OD// Disclaimer: No animals were injured while test driving my F-600 except the ones I ran over intentionally!

---------------------
This post was created using OpenSuSE Linux x64 and Firefox

Charlie, nice job on the custom brackets. Looking good.

1956 Fairlane Victoria (ORREO)

 

Overlooking Beautiful Rimrock AZ

Charlie those look great!! Let me know where to send my money?

       A  L  A  N   F  R  A  K  E  S   ~  Tulsa, OK    

Hey Mike! Motor looks terrific!Nice job.

  

Mike,

If those are 8.5mm wires in the stock brackets, great job! I don't even like putting stock wires in them.



The mock-up of my current setup:










Lawrenceville, GA

Yup, Hate to replace them but they do look nice when dressed properly in original clamps and blocks.

No reason not to go original, all the parts are avaiable reproduction and not expensive

I think wires look best when routed the original way. Mike

1956 Fairlane Victoria (ORREO)

 

Overlooking Beautiful Rimrock AZ

I don't know what truck this outfit came out of - it was on ebay a couple of years ago, sold by a truck repair outfit in California ($250). It sure makes you think that it would be possible to build something like the wire holders fitted to the early Olds V8's though. Longer valve cover studs would let you do a little "inventing"........

 
 Steve Metzger       Tucson, Arizona

i never saw that before.what did it come out of.