I got a 55 driver's door as a replacement for my 56 2dr/ht. As you all know the mouldings are different, therefore the holes for the moulding clips are not in the right place for the 56 stainless and scripe "Victoria". What I need, is for someone who has a 56 driver's dr for a 2dr/ht Victoria without the mouldings installed, make a template. Just a piece of large paper with maybe three location points ie: front edge, rear edge and top or bottom edge. Then just run a carbon pencil over the points where the mounting holes for the clips would be. Is there anyone that can help?. I could wait until the dr is on, but this would be a lot easier with the dr sitting on the bench. Also need the mounting location holes for the Victoria scrip