Ok I'm about to re-install my valley cover I'm convinced thats where the bad leaking has been coming from, high up and at the back of the motor.. Any other ideas helpfull . I dont have the spark wire holders on.. Can leak from there? I have new ones to go on, just need the diagram of where they should go.

The only thing I could see was oil had made it on top of the cover at the back, leaking past the grommet? the bolt could only go so far down and stop, this may have stopped it from being tight enough. I will add some washers to the top so it can go a bit further down. Also the cover looks twisted, is this common to do on install they are a bit of a pain to get in. The gasket was fine and sitting in the right spot just didnt seem to be able to stop the leak even with a bit of non hardening goo on it .. I will do my best at getting it straight and will use an RTV type sealant this time . Is there any other tricks I can do, or something Im missing.. Ohh I do have a PVC outlet as well but all seemed fine with that ...

 Mark I would love to drill and tap but Im going to try without..



"Came too close to dying to stop living now!"