I'm breaking down a '56 312 to send to the machine shop. Must have had factory a/c as it still had the brackets for the York compressor. Pretty neat set up, I'd never seen one before, stout too.

It also had a three stack pulley on the crank which I thought was neat until I found it didn't have the bolt in it. Can't find one to fit, tried to improvise a little with no success.

I usually use a gear puller and screw it down on the bolt and everything just slides right off.

 not this time though.

No, I didn't lose it, or I'd be out there looking for it.

All suggestions welcomed.

Thanks

Missouri Mike

I'd rather be lucky than good.................

    but good ain't bad!!