Profile Picture

Head problems

Posted By scott5560 13 Years Ago
You don't have permission to rate!

Head problems

Author
Message
scott5560
Posted 13 Years Ago
View Quick Profile
Supercharged

Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)Supercharged (77 reputation)

Group: Forum Members
Last Active: 12 Years Ago
Posts: 66, Visits: 354
Motor back in truck and number 6 filled with water GREAT. Thinkin ready to start lol merry christmas GRRRR. After spending $700 on heads. They are ECZ-C heads which I roughly measured at 72cc so stock? Had 0.040" taken off to up comp. And now this. Can this be repaired? Welding? Is this a fluke? Its right at the edge of the firing ring. Or is 0.040 to much for C heads?

Threaded View

Threaded View
Forum Post Head problems By scott5560 ( 13 Years Ago )
Forum Post Taking 0.040” off of the ECZ-C heads shouldn’t be a problem... By Ted ( 13 Years Ago )
Forum Post Here is one pic can only do one at a time as too big. Figured at 72cc... By scott5560 ( 13 Years Ago )
Forum Post Other pic is too big to upload on this forum. This is a heart breaker... By scott5560 ( 13 Years Ago )
Forum Post Were the heads previously used for salt water marine use by chance?... By PF Arcand ( 13 Years Ago )
Forum Post No not used for marine use. Supposed to be the original motor for... By scott5560 ( 13 Years Ago )
Forum Post If the block is C2AE, it's not the original motor.
I think you'll... By charliemccraney ( 13 Years Ago )
Forum Post Ouch! No need to check for bottoming head bolts now :( . I totally... By 46yblock ( 13 Years Ago )
Forum Post I have the original block on a stand had the C2AE block prepped... By scott5560 ( 13 Years Ago )
Forum Post It sounds like the heads were done then run on the original block,... By 46yblock ( 13 Years Ago )
Forum Post I would say the first thing you need to determine, was the hole caused... By John Mummert ( 13 Years Ago )
Forum Post No I not blaming the machine shop at all. I never even thought this... By scott5560 ( 13 Years Ago )
Forum Post Scott: You could possibly fix it yourself. Drill progressively larger... By Hoosier Hurricane ( 13 Years Ago )
Forum Post Got the head back. Took it back to the machine shop. Don't blame him... By scott5560 ( 13 Years Ago )
Forum Post Here is a pic By scott5560 ( 13 Years Ago )
Forum Post Cost some money but much better than scrapping the head! By pegleg ( 13 Years Ago )


Reading This Topic

Site Meter