Profile Picture

Oil leak at high rpms

Posted By Gunner37 13 Years Ago
You don't have permission to rate!

Oil leak at high rpms

Author
Message
Gunner37
Posted 13 Years Ago
View Quick Profile
First Time Poster

First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)First Time Poster (2 reputation)

Group: Forum Members
Last Active: 13 Years Ago
Posts: 2, Visits: 5
I have a 1958 ford custom 300 with a 292.



When I rev up my engine I get about a 6 inch in diameter puddle of oil.

Today I got underneath my car and cleaned the area it looked like it was coming from (around the oil pump). I reved it up to about 3000 rpm and the oil was dripping down the oil pump.

It looked like the oil was comming from the oil line fitting going into the pump from the pan.



Is there suppose to be a oring or seal in this fitting?

Threaded View

Threaded View
Forum Post Oil leak at high rpms By Gunner37 ( 13 Years Ago )
Forum Post There is a rubber packing that goes over the tube and into the oil... By charliemccraney ( 13 Years Ago )
Forum Post I don't know the history of your engine so I have to ask, was it... By The Master Cylinder ( 13 Years Ago )
Forum Post No work has been done to the heads recently. I think I am going to... By Gunner37 ( 13 Years Ago )
Forum Post There should be a bushin like this:... By MoonShadow ( 13 Years Ago )
Forum Post If its leaking from the tube into the pump be careful as it may also... By Talkwrench ( 13 Years Ago )
Forum Post I've seen it where the nut on the inlet to the pump was tightens so... By The Master Cylinder ( 13 Years Ago )
Forum Post OK so i replaced the oil tube seal even though it needed it it did not... By 37gunner ( 13 Years Ago )
Forum Post Looks like the oil filter. By PWH42 ( 13 Years Ago )
Forum Post Very difficult to see with the low lighting: But, it looks to me like... By bergmanj ( 13 Years Ago )
Forum Post its coming from under the oil fitler plate. By 37gunner ( 13 Years Ago )
Forum Post There is a gasket for the filter plate. Do you have an oil pressure... By charliemccraney ( 13 Years Ago )
Forum Post no pressure gauge probably need one... who stocks these gaskets? By 37gunner ( 13 Years Ago )
Forum Post Check your oil filter adapter along with replacing the gasket/o-ring.... By The Master Cylinder ( 13 Years Ago )
Forum Post is it easy to remove this plate? By 37gunner ( 13 Years Ago )
Forum Post You should be able to pick up a gasket at Napa or some other local... By charliemccraney ( 13 Years Ago )
Forum Post Do as Charlie said grind the surface back on your socket so its flat.... By Talkwrench ( 13 Years Ago )
Forum Post Once you’ve removed the oil filter plate, insure that it’s not... By Ted ( 13 Years Ago )
Forum Post Wow, this link,... By JoeBob ( 13 Years Ago )
Forum Post Looks like I have to buy some bigger sockets.... The biggest socket I... By 37gunner ( 13 Years Ago )
Forum Post Done.... Used a socket, hammer and big 4" pipe to "adjust" the filter... By 37gunner ( 13 Years Ago )


Reading This Topic

Site Meter