I just got my Bendtsen kit to install AOD/ I pick up trans wed /my ? is can installed be done with out pulling engine ?

Sure it could be done that way, anythings possible- but seems more difficult to me.

       A  L  A  N   F  R  A  K  E  S   ~  Tulsa, OK    

Other than grinding the transmission case for starter clearence it shouldn't be any different than changing a transmission. You will have to fab up a transmission mount and drive shaft. Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Lot of variables depending on what motor you have and what transmission your AOD is replacing.

Darrell Howard Whitefish, MT Outlaw 56 Ford F-100's

I'll agree with that!

I have bolted my 292/E4OD together and took it apart so many times that I wouldn't even think of doing again it without having the engine out and sitting on a pallet etc!! I still need to fabricate the cross piece!

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1955 F-600/272/E4OD// Disclaimer: No animals were injured while test driving my F-600 except the ones I ran over intentionally!

---------------------
This post was created using OpenSuSE Linux x64 and Firefox