Profile Picture

292 Oil Pan Leak After New Gasket

Posted By '59Edsel 12 Years Ago
You don't have permission to rate!

292 Oil Pan Leak After New Gasket

Author
Message
'59Edsel
Posted 12 Years Ago
View Quick Profile
Supercharged

Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)Supercharged (422 reputation)

Group: Forum Members
Last Active: 10 Years Ago
Posts: 163, Visits: 3.5K
Hey everyone,

I just recently installed a new cork oil pan gasket including gasket sealer, but still ended up with a leak. I torqued everything down to spec and from the center out like it said, but here is the result:

https://www.youtube.com/watch?v=IT3BUrpeM10

Any tips? Or do I need to tear it back down and start over?

http://oi43.tinypic.com/vyxn49.jpg

Threaded View

Threaded View
Forum Post 292 Oil Pan Leak After New Gasket By '59Edsel ( 12 Years Ago )
Forum Post Drain the oil out, pull it off and make sure it's straight. You can... By pegleg ( 12 Years Ago )
Forum Post I with Frank on this one. The pan rail may be a bit bent in that area.... By MoonShadow ( 12 Years Ago )
Forum Post [quote][b]'59Edsel (6/1/2013)[/b][hr]Hey everyone, I just recently... By aussiebill ( 12 Years Ago )
Forum Post Torquing it may be your mistake. I don't torque many cork gaskets.... By charliemccraney ( 12 Years Ago )
Forum Post Agree with what others have said. That's a lot of leaking, check the... By bird55 ( 12 Years Ago )
Forum Post Now that is daylight and I'm fully (?) awake. You could try taking a... By MoonShadow ( 12 Years Ago )
Forum Post Well guys, the gasket is too squished to make anything worth... By '59Edsel ( 12 Years Ago )
Forum Post Before putting the pan back on, check to make sure the pan sealing rim... By 56_Fairlane ( 12 Years Ago )
Forum Post Will do! By '59Edsel ( 12 Years Ago )
Forum Post Many times the holes have been tightened too tight in the past and... By 312T85Bird ( 12 Years Ago )
Forum Post I agree with 312T85Bird, you have to reflatten each hole. I usually... By Y block Billy ( 12 Years Ago )
Forum Post Get the gasket set that has a new O ring for the oil pump and other... By Talkwrench ( 12 Years Ago )
Forum Post Thank you, thank you. I have an exciting weekend ahead. By '59Edsel ( 12 Years Ago )
Forum Post Are you sure the rear seal isn't in the way? It could cause a small... By lameyer ( 12 Years Ago )
Forum Post Thanks for all the help guys, the problem was found out and a new... By '59Edsel ( 12 Years Ago )
Forum Post And the problem was??? By Talkwrench ( 12 Years Ago )
Forum Post [quote][b]Talkwrench (6/21/2013)[/b][hr]And the problem was???[/quote]... By '59Edsel ( 12 Years Ago )
Forum Post Gee, I'm glad that never happened to me!! :rolleyes: By pegleg ( 12 Years Ago )


Reading This Topic

Site Meter