I need to know if there is a bigger manual flywheel than a 10 or 10.5 inch unit?  I would prefer an 11 inch, but is the capability to contain it there?  Will the new Quicktime bellhousings hold an 11 inch or am I stuck with the smaller flywheels?  If I am to use a 10.5, I will probably use a Spec or something similar with sintered iron facing.  Not concerned so much with chatter as I am with grip and performance. 

By the way, I just picked up a 292 to stab in while I build the turbo 292.  That's why I need the flywheel info now, gonna run it with a toploader 4 gear.   Hopefully, I will be picking up the 292 block and crank from Glen on the way back from Spring Swap in Columbus.  Can't wait to get started on that one...

James Potter
`57 Fords International



`57 Custom Tudor

`57 Fords International National Director

Pass Christian, MS (near Gulfport/Biloxi)