Profile Picture

Holley 4160 Carb Hesitation

Posted By Nat Santamaria 16 Years Ago
You don't have permission to rate!
Author
Message
Nat Santamaria
Posted 16 Years Ago
View Quick Profile
Supercharged

Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)Supercharged (251 reputation)

Group: Forum Members
Last Active: 3 Years Ago
Posts: 165, Visits: 4.8K
Hi Guys. This winter I installed my Holley 4160 carb on my 57 T-bird. It has the Fordomatic tranny. I have Pertonix ignition, Flamethrower Coil, new wires, new plugs (gapped at .044). I took it out today for a test run. Car starts easily, once warmed up it idles quite smoothly and quietly. When pulling away from a light it stumbles. I have to let up on the gas pedal a bit to keeping it from bogging and stalling. If I work the accelerator linkage sharply (car is at idle in park), the engine stumbles before it revs up. The new 4160 carb has 8.5 power valves. Float issue? Plug gap too wide? I did not have this issue before replacing the carb. Any Ideas?



Many thanks

Threaded View

Threaded View
Forum Post Holley 4160 Carb Hesitation By Nat Santamaria ( 16 Years Ago )
Forum Post Is the carburetor the only thing you have changed/tweaked/tinkered... By charliemccraney ( 16 Years Ago )
Forum Post Could be the accelerator pump. With the engine OFF, look down into... By Pete 55Tbird ( 16 Years Ago )
Forum Post First thing to check is that the carb was put together tightly enough... By rgrove ( 16 Years Ago )
Forum Post Personally I would go back to .035 on the plugs unless you are running... By crab ( 16 Years Ago )
Forum Post I had the same problem with a 4160 years ago, and it turned out it had... By miker ( 16 Years Ago )
Forum Post Exactly what ours had #55. I wonder if todays fuel requires larger... By crab ( 16 Years Ago )
Forum Post [quote][b]crab (3/4/2009)[/b][hr]Exactly what ours had #55. I wonder... By crab ( 16 Years Ago )
Forum Post I checked the squirters and appear to be getting an even stream of... By Nat Santamaria ( 16 Years Ago )
Forum Post If your letting up on the throttle to make it get better it sounds... By uncleaud ( 16 Years Ago )
Forum Post Interesting, my kit also had an 8.5 PV in it, the origiinal had no... By crab ( 16 Years Ago )
Forum Post I re gapped the plugs back to .036 - no difference. The Holley rep... By Nat Santamaria ( 16 Years Ago )
Forum Post Longshot, but check your vacume source for proper vacume, I think its... By crab ( 16 Years Ago )
Forum Post Have you checked to make sure the base plate is tight enough?... By rgrove ( 16 Years Ago )
Forum Post Nat,Something else to check is the float level.Make sure the motor is... By oldcarmark ( 16 Years Ago )
Forum Post [quote][b]oldcarmark (3/5/2009)[/b][hr]The power valve should be rated... By Ted ( 16 Years Ago )
Forum Post Hello Ted, I got the info about power valves from the Holley... By oldcarmark ( 16 Years Ago )
Forum Post Nat. Time for some HOMEWORK on your part. We need to know. !, what is... By Pete 55Tbird ( 16 Years Ago )
Forum Post The 450 should be fine. I have a lack of knowledge about Holley carbs... By charliemccraney ( 16 Years Ago )
Forum Post At first it sounded like the accelerator pump adjustment but with... By Ted ( 16 Years Ago )
Forum Post Nat - Do you have an auto (Ford-o-Matic) tranny in your bird? Because... By GREENBIRD56 ( 16 Years Ago )
Forum Post Hi guys.
1957 Tbird 312, Fordomatic.
As a recall I am...
By Nat Santamaria ( 16 Years Ago )
Forum Post Hello Nat, What was the original problem which made you think the... By oldcarmark ( 16 Years Ago )
Forum Post Nat; Mark is right on, if you don't even know if the engine is timed... By PF Arcand ( 16 Years Ago )
Forum Post Thanks guys I will have a mechanic check the timing. My original... By Nat Santamaria ( 16 Years Ago )
Forum Post Hello Nat, If the only thing you changed besides the carb is the... By oldcarmark ( 16 Years Ago )
Forum Post [quote][b]Nat Santamaria (3/19/2009)[/b][hr]I will have a mechanic... By Ted ( 16 Years Ago )
Forum Post And from memory, the pertronix is straight battery voltage, you can't... By crab ( 16 Years Ago )


Reading This Topic


Site Meter